Seaguar Community - Surgeon's Knot Details

	Seaguar Community

	Knot Guide

	Fishing Line Q&A

	Fluorocarbon Myths

	E-News Sign-Up

Home > Seaguar Community > Knot Guide > Surgeon's Knot

This image placeholder will be replaced by the Clinch Knot Animation

		Step 1 To start, place two lines parallel to each other, with the ends pointing in opposite directions. Overlap the lines about 8 inches and it's OK to use more line if needed.

		Step 2 Hold the two lines together. While treating them as a single line, tie an overhand knot.

		Step 3 Then take the two lines togther and tie an overhand knot. Pull the entire leader through the loop.

		Step 4 Pass the lines through the loop a second time as shown.

		Step 5 Finish by tightening each of the two individual knots… Hold the lines on each end of the knot and pull tight.

		Step 6 Trim the tag ends, and your done!

Back to Top ›››

Surgeon's KNOT

To tie a Surgeon's Knot, there are six basic steps to follow. You can play and pause the animation to view each step in detail. We have also included on this page, step-by-step written instructions along with illustrations and diagrams for each step.

It's important to note that while our animation shows only two loops, you can tie a knot with 4 or 5 loops depending on the line's diameter.

PRO TIP

Remember, to tie a good tight knot it is important give yourself enough line to work with, and to keep your lines very moist. A good tip from one of our pros on keeping your line moist and pliable is to use Chap Stick - Try it; it's a wonderful thing!